Interactive quality engineering tool
Material Specification Compliance Checker
Compare actual material evidence with controlled CSA, ASTM, API, customer, or internal requirements. Every result shows the entered rule, unit conversion, and evidence basis.
Important engineering-use notice
This tool supports screening and documented comparison. It does not contain authoritative acceptance limits, grant certification, or replace the controlled purchased edition of a standard, purchasing specification, contract requirements, or approval by the responsible engineer or customer.
Define the comparison
Material and specification scope
Identify the material, source certification, controlled target requirement, product form, and applicable dimensions.
Select evidence
Independent compliance workbench
Evaluate only the sections relevant to the decision. A selected section with no configured requirements produces a conditional result.
Enter evidence and limits
Actual results and target requirements
Enter acceptance limits from the controlled source. Units are converted only where a defined engineering conversion exists.
Row-level units take priority. Each actual result and requirement has its own unit selection.
Review the evidence
Compliance decision
Conservative gating is used: any failure causes Fail; unresolved mandatory evidence causes Conditional.
Run the checker after entering requirements and actual results.
| Section | Requirement | Actual | Acceptance rule | Result | Basis |
|---|---|---|---|---|---|
| No assessment has been run. | |||||
Document the assessment